BlockSim supports all of the following fault tree analysis diagram configurations.

Fault Tree Diagrams with AND Gate Configurations
If both input events (A and B) occur, then the output event (system failure) will occur. 

Fault Tree Diagrams with OR Gate Configurations
If any of the input events (A or B or C) occurs, then the output event (system failure) will occur.

Fault Tree Diagrams with Voting OR Gate Configurations
If a specified number of the input events occur (A and B, A and C, or B and C), then the output event (system failure) will occur.

Fault Tree Diagrams with Inhibit Gate Configurations
If the input events (A and B) and another conditional event (C) occur, then the output event (system failure) will occur.

Fault Tree Diagrams with Load Sharing Gate Configurations
The probability of occurrence for each input event (BA, BB and BC) is dependent on the occurrence of the other events.

Fault Tree Diagrams with Standby Gate Configurations
If the active input event (A) occurs then the standby input events (B and C) occur, then the output event (system failure) will occur. 

Fault Tree Diagrams with Combinations of Gates
The output event (system failure) will occur if A, B, C or D occurs or if 2 out of three of E, F or G occurs or if any of H, I, J, K or L occurs and any of M, N, O or P and Q occurs.

The Ultimate System Visualization and Analysis Tool...   ReliaSoft's BlockSim is designed for system reliability, maintainability, availability, optimization, throughput, cost analysis and more...

[Home]   [Software]   [Training]   [Consulting]   [Resources]   [Corporate]   [Search]   [Site Map]   [weibull.com]
ReliaSoft is a registered trademark of ReliaSoft Corporation in the United States and other countries. Contact: Worldwide Office Numbers	LEGAL [Terms of Use] [Linking Guidelines] [On-Line Privacy Statement]
Add RSS Feeds
Copyright ©1992-2008 ReliaSoft Corporation, All Rights Reserved	Contact Webmaster